SMEG CLASSIQUE OVEN DOOR SEAL GASKET FOR 90CM OVENS - 754131050

A flattened, brittle, or torn oven door seal lets hot air escape around the door, lengthens preheat times, causes uneven baking, and can leave heat marks on adjacent cabinetry. This is a new replacement oven door seal gasket for selected Smeg and Classique 90cm ovens, supplied as an original manufacturer part with code 754131050 and dimensions 780mm x 330mm.

It is the perimeter seal that runs around the front of the oven cavity. Replacing it is one of the simplest, most effective ways to bring an older oven back to spec without major service work.

Key Features

• New replacement oven door seal gasket
• Original manufacturer part
• Part code: 754131050
• Dimensions: 780mm x 330mm
• Verified for a wide range of Smeg, Classique, and SUK 90cm freestanding ovens
• Restores oven heat retention, reduces preheat times, and improves baking consistency
• 12 month minimum warranty (subject to manufacturer’s terms)

Product Details

• Product code: 754131050
• Dimensions: 780mm x 330mm
• Type: Original manufacturer oven door seal gasket
• Application: Selected Smeg and Classique 90cm freestanding ovens
• Condition: Brand new
• Stock note: NZ distributor for this brand is currently in liquidation, so lead times may be longer than usual. Check ETA on the product page before ordering.
• Also known as: 754131050

Compatibility

This door seal is verified compatible with a wide range of Smeg and Classique 90cm freestanding ovens sold in New Zealand, including the SNZ90MFX, SNZ91MFX, SNZ91MFX.1, SNZ91MFA, SNZ91MFA1, C9GMXA, C9GMXA1, C9GMNA, C9GMNA1, C9GMBA, C9GMBA1, C9GMB1, C9GMN, C9CMXA, C9CMXA1, C9IMXA, C9IMXA1, CE9IMXA, TR90X, TR90X1, TR90BL Victoria, SA9010X, SA9065XS, SA9066AS, SA9066XS, SUK91MFA, SUK91MFX (replaced by SNZ91MFX), SUK91CMX5, SUK91CMX7, plus the Classique CL90FCEX and CL90FGAX 90cm freestanding ovens. The verified models list appears in the table at the end of this description. Always confirm the existing seal dimensions are 780mm x 330mm before ordering, since some 90cm models use a slightly different perimeter size, and verify the part code on the appliance documentation if unsure.

How to Use and Installation Notes

1. Switch off the oven at the wall and let it cool fully.
2. Open the oven door and locate the existing seal around the front face of the oven cavity.
3. Lift one corner of the old seal and gently pull it out of its retaining clips or channel.
4. Wipe the channel clean with a damp cloth to remove any old grease or food residue.
5. Note the orientation of the new 754131050 seal, with the rounded face outward to press against the inner door glass.
6. Push the new seal into the retaining clips at the corners first, then work the rest of the seal around the cavity evenly.
7. Close the door and check for an even, soft compression all the way around the perimeter.

Fitting and Safety Note

Related Parts and Collections

• Oven door seals collection
• Smeg parts collection
• Classique, Baumatic, and Omega parts collection

Verified Compatible Models